NIU Scooter Wireless Remote Keystart Accessory

Description

NIU Wireless Keystart Accessory

With the newer generations of NIU scooters, they have a feature where the scooter can be started without having to use the physical key to unlock the scooter. With this wireless key start accessory, you can separately install this feature onto your scooter, so that even older models are able to start the scooter without having the scooter key at hand. If you still want to start the scooter using the original key, it is still possible.

Step-by-Step Instructions for Installing the Wireless Key Accessory on Your Scooter

Step 1: Connect the Headlight Circuit
– Locate the two large plugs from the accessory.
– Connect these plugs to the headlight circuit of your scooter.

Step 2: Connect the Steering Lock Circuit
– Identify the two smaller pieces from the accessory.
– Connect these pieces to the steering lock circuit.
– Refer to the video to see the exact placement of these smaller pieces.
– Ensure you have the correct pieces by checking for the black and red cables in the original steering lock circuit.

Step 3: Pair the Wireless Key Accessory
– Turn on the scooter.
– Press and hold the small button on the new wireless key accessory for about 10 seconds.
– Look for a red light flashing at the bottom of the accessory box.
– Once the light starts flashing, press the button again shortly .
– Press the alarm button or the unlock button on your scooter keypad to start matching.
– Shortly press the alarm or unlock button once and observe the reaction in the box.
– Press the button again once you see a reaction.
– When the accessory is correctly matched, you will be able to turn the scooter on and off using the accessory.

 Troubleshooting Tips
1. Ensure Proper Connections:
– Make sure all circuits are properly connected: the accessory should be connected to both the headlight and steering lock circuits.

2. Check for Proper Matching:
– If the accessory doesn’t work, ensure it is properly matched.
– The flashing light is at the bottom of the accessory box.
– Repeat the installation steps a few times if necessary.