NIU N-Series / UQI GT / UQI+ Remote Speed Limiter Accessory

Description

NIU N-Series / UQI GT / UQI+ Remote Speed Limiter Accessory

With the use of this accessory you will be able to limit the speed of your NIU N-Series / UQI GT / UQI+ scooter. By pressing the remote you will be able to lock the mode switcher so that it can only go down in modes and not up. With our programmable motherboards you are able to set the speed of mode 1 to your liking.

Features: 

• The scooter will not be able to switch up to mode 2 or 3 unless the speed limiter is unlocked by pressing the remote.
• Turning the scooter off and on will not make a difference as regardless the accessory will result in the scooter being locked in mode 1.

Installation

The installation is simple and is doable within 20 minutes.

1. Removing the Front panel
   1. Remove the two caps covering the screws and unscrew the two screws.
   2. Remove the two screws that secure the top part of the front panel
   3. Remove the two plastic screws on the bottom side of the front panel (You have to use a screw driver to push the two plastic screws in and then pull them out)
   4. Remove the front panel by pushing it up and disconnecting the headlight connector.
2. Adding the accessory
   1. Add the white heads into the circuit of the headlight
   2. Add the black heads into the circuit of the mode switch
      1. Match the accessory to the remote by opening the white box
      2. Long hold the button inside the accessory until it starts to blink, then short press the button and finally press the button of the remote to match the remote.

How do you know you have the correct connector? When the correct connector is unplugged and you try to switch modes the mode switcher will not work this means that you have the correct connector that is responsible for circuit of the mode switcher.